Cetol TSI Satin Plus is a medium build solvent-borne interior woodstain, for decoration and protection on smoothplaned softwood and hardwood. A single product system, providing a hardwearing finish resistant to knocks, spills and abrasion. Cetol TSI Satin plus has a strong surface film, and is resistant to water and mild household detergents. Cetol TSI Satin plus can be used on floors subject to light domestic wear.For use on window frames, handrails, skirtings, wood panelling, doors, furniture etc. in coloured and colourless finishes.

Brand Name	Sikkens
Colour	N/A
Material	wood
Manufacturer Model No	N/A
Wear Type	interior
Type	woodstain
Certifications Met	N/A
Country of Origin	N/A
Protects From	abrasion, spills
Waterproof	N/A
Number of Pockets	N/A
Product Type	Wood Stain
Short Description	A medium build, solvent-borne interior woodstain providing a satin finish.
Drying time (recoat)	16 hours
Drying time (touch dry)	6-8 hours
Suitable Surface	Door frames, Furniture, Doors, Skirting boards, Window frames, Wood
Coverage	11 -13 m²/L
General No. of Coats	3
Application description	Ensure product is thoroughly stirred before and during application, otherwise sheen and colour variations may be experienced. Cetol TSI Satin plus is supplied ready for use and does not require thinning. For best results use a good quality, long-haired soft bristle brush. Three coats of Cetol TSI Satin plus should be applied, allowing a minimum of 16 hours drying time between coats. The product should be applied in a full flowing coat, laying off in the direction of the grain, using the minimum number of brushstrokes necessary to produce an acceptable finish. Avoid overbrushing, as this will produce brush marks and a poor quality finish. Apply to a minimum wet film thickness of 54 micrometres. Conditions – Do not apply when air/substrate temperatures are below 5ºC or above 30ºC during application or drying periods.Protect from water until dry. Failure to meet these requirements may adversely affect the drying, visual quality and durability of the finish. The first coat should be carefully denibbed using a fine grade nylon abrasive pad or a fine grade (P240 or finer) wet or dry silicon carbide abrasive paper, in the direction of the grain. Do not break through the surface coating. Remove all dust. Subsequent coatings should be applied as soon as possible after the previous coat has dried, but no sooner than 16 hours.
Cleaning	Clean brushes and equipment with brush cleaner immediately after use. If spilled, Cetol TSI Satin plus may be removed immediately while still wet using white spirit
Storage	Store in cool, dry, frost-free conditions